close
close

How To Light Pilot Light On Old Gas Fireplace 2022

How To Light Pilot Light On Old Gas Fireplace 2022. An older gas furnace has a standing pilot that stays on all the time — or at least, it's supposed to. Because this is the first light of the season, it may take a while for the gas to reach the pilot.

How To Relight A Pilot Light On A Furnace How to Guide 2022
How To Relight A Pilot Light On A Furnace How to Guide 2022 from friendslostboys.org

An older gas furnace has a standing pilot that stays on all the time — or at least, it's supposed to. Light a match or butane candle lighter and hold it near the burner in the fireplace. Once the pilot lights, keep holding down the gas control knob for 20 to 30 seconds to allow time for heating up the thermocouple (a safety device), then release the knob so it pops back up.

Has The Pilot Light On Your Fireplace Gone Out?

The pilot light in a gas fireplace is typically found adjacent to the main burner, below the fireplace media such as logs or coals. Press and hold down the gas control knob, then press the igniter button multiple times, as needed, until the pilot flame ignites. You can adjust the flame height by turning the gas key.

If You Keep The Fireplace Switch In The On Position, The Receiver Will Stay On Until You Slide It To The Remote Or Off Position.

A number of things can make an old furnace pilot light go out, including a strong draft, a faulty thermocouple or a loss of gas. Keep a close eye on your pilot light once you have restored the flame. Hold the gas control button down while you hold the end of a lighted match or lighter at the end of the pilot tube.

An Older Gas Furnace Has A Standing Pilot That Stays On All The Time — Or At Least, It's Supposed To.

When the flame sensor goes out, it causes the pilot light to stop functioning. Hold the control knob in for an additional 10 seconds to prevent the ods pilot from shutting off the gas while the thermocouple. I have a rodgers thermostat and the fire symbol is.

Once The Pilot Stays Lit By Itself, Turn The Gas Flow Knob To The “On” Position.

If power is actively supplied to your fireplace, simply turn the on/off. A modern gas furnace usually has an electronic spark generator to ignite the gas when the thermostat calls for heat. It is the flame sensor that tends to go out in situations such as these.

Where Is The Pilot Light On A Gas Fireplace?

Light a match or butane candle lighter and hold it near the burner in the fireplace. Once the pilot lights, keep holding down the gas control knob for 20 to 30 seconds to allow time for heating up the thermocouple (a safety device), then release the knob so it pops back up. The pilot, found as part of the ignition, can often be seen when looking down from above within the firebox or below through the control area.

Tags :

Leave a Reply

Your email address will not be published.